WPWEKO speed worm reducer gearbox jack speed reducer

概要

Quick Details

Place of Origin:

Zhejiang, China

Brand Name:

EPT

Model Number:

WPWEKO

Rated Power:

0.12-15

Gearing Arrangement:

ワーム

Output Torque:

17-2754

Input Speed:

1400

Output Speed:

5-250

Supply Ability

Supply Ability:

200 Set/Sets per Day

Packaging & Delivery

Packaging Details

Wooden cases or according to customers' requirements”>Out packing:

Wooden cases or according to customers' requirements

Online Customization

Features:
1. Widely used in turbines, shaft liners and axletrees; good resistance to wearing,with
high precision in dimensions, lower noise, advanced centric running castings
2. Without air vent and highly precision
3. The whole structure is compact and the weight is larger

1.Notices of installation

1.1 Thebase-plate must be plane and stoutness, and the base-plate must be screwed downand shockproof.

1.2 Theconnecting shaft of prime mover, reducer and operation device must be coaxialinstallation.

1.3 Thediameter tolerance zone of input and output shaft is H6, the holes of fittings(such as couplings, belt-pulley, sprocket wheel and so on) must properly matethe shaft ,which prevents bearing from breakage because of over-loose mate.

1.4 Driverssuch as sprocket wheel and gear must be fitted close to bearings in order toreduce bending stress of hanging shaft.

1.5 Whiteassembling motor of WPD reducer, it is necessary that proper amount of butterapplies to the worm shaft input hole and keyway, avoiding assembling tootightly and rusting after using for a long time.

1.6 WhenOrdering or using all kinds of WPD type, if the motor weight is binger than thecommon, supporting set is required.

2. Notices ofusage

2.1Before using, please check carefully whether the reducer model, distance,ratio, input connecting method, output shaft structure, input and output shaftdirection and revolving direction accord with requirement.

2.2According to the requirement of selecting lubricant oil in the productmanual, please fill proper category and brand lubricant. And then screw on thevent-plug; unlock the small cone-plug of vent-plug. Only after doing these,reducer is already for starting up running. The proper brand and adequatelubricant oil is required, replacing oil in time conforming to the request ofproduct manual is also necessary, especially after using first 100 hours, it isrequired refilling new oil.

2.3 Whenabnormal circumstances occur, please stop and check reducer per solutions andreasons for faults of reducer (allowable highest oil temperature is 95, under this temperature limit, ifoil temperature no more goes up, please let reducer continue running)